IEI Integration IMBA-Q454 v1.01 - Manual (Page 118)

IMBA-Q454-R10 User Manual
Page 118
Î
Enabled Remote access configuration options shown below
appear:
-- Serial Port Number
-- Serial Port Mode
-- Flow Control
-- Redirection after BIOS POST
-- Terminal Type
-- VT-UTF8 Combo Key Support
-- Sredir Memory Display Delay
These configuration options are discussed below.
Î Serial Port Number [COM1]
Use the Serial Port Number option to select the serial port used for remote access.
Î
COM1 D EFAULT System is remotely accessed through COM1
Î
COM2 System is remotely accessed through COM2
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Î Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Î Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1
ƒ 19200 8,n,1
ƒ 09600 8,n,1