IEI Integration IMBA-Q454 v1.01 - Manual (Page 112)

IMBA-Q454-R10 User Manual
Page 112
5.3.6 AHCI Configuration
Use the AHCI Configuration Settings menu (
8
BIOS Menu 9) to report on the
auto-detection of devices connected to the onboard SATA drive connectors.
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Exit
AHCI Settings
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
AHCI CD/DVD Boot Time out
[15]
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
> AHCI Port0 [Not Detected]
> AHCI Port1 [Not Detected]
> AHCI Port2 [Not Detected]
> AHCI Port3 [Not Detected]
> AHCI Port4 [Not Detected]
> AHCI Port5 [Not Detected]
Some SATA CD/DVD in AHCI
mode need to wait ready
longer
ÅÆ Select
Screen
↑ ↓ Select
Item
Enter Go to SubScreen
F1 General
Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 9: AHCI Configuration
Î AHCI Port n [Not Detected]
Use the AHCI Port n BIOS option to check which AHCI (Advanced Host Controller
Interface) devices are detected on a specified SATA drive connector. If a device is
detected, selecting the BIOS option, e.g. “AHCI Port 3” opens a new window.
5.3.6.1 AHCI Port n
Use the AHCI Port n configuration menu (Error! Reference source not found.) to configure
the drive connected to SATA connector n.