IEI Integration IMBA-Q454 v1.01 - Manual (Page 184)

IMBA-Q454-R10 User Manual
Page 184
Step 2: Check the high or low limit value to have the system use the beep warning when
the specified fan speed is greater or smaller than the high limit or low limit
(
975H
Figure 8-9). (Make sure to enable beep/audio alarm on the Load/Save Page.
Refer to Section
976H
8.8) Step 0:
8.4.3 Smart Fan Setting
The Smart Fan Setting page is for advanced fan setting. The user can enable or disable
the specific fan. When the fan is enabled, the user can control the fan in three different
modes (On/Off Mode, PWM Mode and Automatic Mode).
8.4.3.1 On/Off Mode
In the On/Off Mode, choose Off or On to turn off or turn on the fan. Click apply or ok when
finish.
Figure 8-10: Smart Fan Setting – On/Off Mode
8.4.3.2 PWM Mode
In the PWM Mode, the user can set the PWM value from 0 to 127 by entering a value
(
977H
Figure 8-11). To set the value, double click the number and enter a new value. Click
apply or ok when finish.