IEI Integration IMBA-Q454 v1.01 - Manual (Page 64)

IMBA-Q454-R10 User Manual
Page 64
o When working with the IMBA-Q454-R10, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the IMBA-Q454-R10 DO NOT:
ƒ Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
ƒ Use the product before verifying all the cables and power connectors are
properly connected.
ƒ Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 CPU, CPU Cooling Kit and DIMM Installation
WARNING:
A CPU should never be turned on without the specified cooling kit
being installed. If the cooling kit (heat sink and fan) is not properly
installed and the system turned on, permanent damage to the CPU,
IMBA-Q454-R10 and other electronic components attached to the
system may be incurred. Running a CPU without a cooling kit may also
result in injury to the user.
The CPU, CPU cooling kit and DIMM are the most critical components of the
IMBA-Q454-R10. If one of these component is not installed the IMBA-Q454-R10 cannot
run.
4.3.1 Socket LGA775 CPU Installation
NOTE:
To enable Hyper-Threading Technology, the CPU, chipset and
operating system must all support Hyper-Threading Technology.