IEI Integration IMBA-Q454 v1.01 - Manual (Page 188)

IMBA-Q454-R10 User Manual
Page 188
8.5.2 High Limit Value and Low Limit Value Setting
The high limit value and low limit value of each temperature can be set by the user. When
the temperature is greater than the high limit value or less than the low limit value, the
temperature value shows in red. For example, the SYSTEM1 temperature (48) shows in
red in
982H
Figure 8-13 since the current system temperature is greater than the high limit
value (40). The temperature scale can be changed from Celsius scale (°C) to Fahrenheit
scale (°F).
To set the high limit value or low limit value, follow the steps below.
Step 1: Double click a high limit value or a low limit value to enter the new value
(
983H
Figure 8-15).
Figure 8-15: Temperature Page – High Limit and Low Limit
Step 2: Check the high or low limit value to have the system use the beep warning when
the specified temperature is greater or lower than the high limit or low limit
(
984H
Figure 8-15). (Make sure to enable beep/audio alarm on the Load/Save Page.
Refer to Section
985H
8.8). (Make sure to enable beep/audio alarm on the Load/Save
Page.) Step 0: