beautypg.com

4 serial device, Figure 4-18: parallel device connector – IEI Integration IMBA-Q454 v1.01 User Manual

Page 85

background image

IMBA-Q454-R10 User Manual

Page 85

Figure 4-18: Parallel Device Connector

Step 3:

Secure the connector. Secure the DB-25 connector to the external interface by

tightening the two retention screws on either side of the connector.

Step 0:

4.6.4 Serial Device

The IMBA-Q454-R10 has a single female DB-9 connector on the external peripheral

interface panel for a serial device. Follow the steps below to connect a serial device to the

IMBA-Q454-R10.

Step 1:

Locate the DB-9 connector. The location of the DB-9 connector is shown in

Chapter 3.

Step 2:

Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the external peripheral interface. See

8

Figure 4-19.

See also other documents in the category IEI Integration Hardware: