Figure 4-15: four port usb cable connection – IEI Integration IMBA-Q454 v1.01 User Manual

Page 81

IMBA-Q454-R10 User Manual

Page 81

Step 1:

Locate the connectors. The locations of the USB connectors are shown in

Chapter 4.

WARNING:

If the USB pins are not properly aligned, the USB device can burn out.

Step 2:

Align the connectors. Each cable has two connectors. Correctly align pin 1on

each cable connector with pin 1 on the IMBA-Q454-R10 USB connectors.

Step 3:

Insert the cable connectors.

Once the cable connectors are properly aligned

with the USB connectors on the IMBA-Q454-R10, connect the cable connectors

to the on-board connectors. See

Figure 4-14.

Figure 4-15: Four Port USB Cable Connection

Step 4:

Attach the bracket to the chassis. The USB 2.0 connectors are attached to a

bracket. To secure the bracket to the chassis please refer to the installation

instructions that came with the chassis.

Step 0: