How to reset the 1pp2s output on the timing module – Agilent Technologies Wireless Network Optimization Platform E6474A User Manual
Page 56
![background image](/manuals/35438/56/background.png)
56
Agilent E6474A User’s Guide
3
Set Up Your System
How to reset the 1PP2S output on the timing module
The timing module is factory configured to provide a 1PP2S
timing pulse. If, however, the timing pulse has been changed
to 1PPS
1
, then use the following procedure to change the
timing module output.
This procedure requires the GPSMon software to
communicate with the timing module. Refer to the timing
module manufacturer’s instruction for installing and
configuring the GPSMon software.
1 Connect the timing module to your laptop
2 Provide power to the timing module using a battery or AC
mains
3 From the GPSMon software, select Setup > Ref Pulse
Figure 29
Open the Ref Pulse dialog box
4 In the Ref Pulse Control dialog box, select 1PP2S option.
1 This may occur when a factory reset command is sent to the module.