Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 128)

128 Agilent E6474A User’s Guide
6 Getting Assistance, If You Need It
Updating Receiver Firmware
1 In the Hardware panel, configure a receiver and receiver
measurement. Once data logging starts, the E6474A
software determines if the Agilent E645xC digital receiver
has the correct firmware. If not, the message box in
Figure 103 appears.
Figure 103 Firmware upgrade required, first dialog box
NOTE
The Agilent W1314A receiver range uses a software-enabled firmware
upgrade process that is managed by the E6474A software. If the firmware
or internal components require updating, follow the instructions provided
when you try to connect your receiver to the software application.
NOTE
If your hardware configuration includes daisy-chained E645xx receivers,
you must first disconnect the receivers, then connect one receiver at a
time, and upgrade the firmware on each receiver. When you are finished
updating the firmware, reconnect the daisy-chain, and reconfigure the
daisy-chained receivers.