Agilent Technologies Wireless Network Optimization Platform E6474A - Manual (Page 36)

36 Agilent E6474A User’s Guide
3 Set Up Your System
To connect multiple E645xC receivers:
1 Attach one end of a short cable to the RX LOOP IN
connector on the master receiver. Attach the other end of
the short cable to the RX LOOP OUT of the second
receiver.
2 Continue to attach receivers (up to a total of four
receivers) as in step 1.
3 When all receivers are connected with short cables,
connect one end of a long cable to the RX LOOP OUT
connector on the master receiver to the RX LOOP IN on
the last receiver in the series.
4 Connect the serial port of your laptop to the RS- 232 port
of the master receiver with an RS- 232 null modem cable.
5 Connect the RF antenna to the RF input of each of the
receivers.
6 Connect the GPS antenna to the SMA GPS Connector of
the master receiver.
Refer to Figure 16 on page 37.