IAI America RCA2-TW4N - Manual (Page 85)

77
9. Installation
(TCA3NA, TCA3N (Slide screw, Ball screw)) (TCA4NA, TCA4N (Slide screw, Ball screw))
Caution: A work part shall be mounted on a machined plane or a plane with equivalent precision,
and the flatness shall be 0.01 mm/m or less. If sufficient flatness is not secured, the table
is deformed when mounting and fixing a work part, causing malfunction.
Flatness refers to the height difference between the maximum value (peak) and
minimum value (trough) of surface distortion.
The length of screws used to mount a work part must the effective screw depth
described here or less.
If a screw is screwed in more than the effective screw depth, the end may get into
contact with the guide rail and the table may be deformed, causing malfunction.
depth 3 depth 3
4-M4 depth 5.5
4-M4 depth 5.5 depth 3
depth 3
Home
Table upper surface Table upper surface
F F