IAI America RCA2-TW4N - Manual (Page 44)

36
4. Options
4. Options
4.1 Optional Connector Cable Exit Direction
In the standard specification, the cable exit direction is opposite to the rod and guide bracket.
If it is desired to pull out the cable on the front plate side according to the device layout, etc., the cable can
be pulled out from the opposite direction by using the option (model number: K2).
4.2 Power-saving Function
This option reduces the maximum current of the controller compared to actuator of the standard specification.
The maximum current varies depending on the model.
Please refer to the power supply capacity in the catalog or each operation manual of ACON, ASEL, ASEP,
or AMEC controller. The model number is indicated as HS.
4.3 Brake Type
The brake is a mechanism designed to prevent the table from dropping when the power or servo is turned
off on an actuator of motor unit (TA**) type used vertically.
Use the brake to prevent the installed load, etc., from being damaged due to the falling table.
4.4 Reversed-home Specification
On motor unit types (TA**), the standard home position is on the motor side. However, you can specify an
option to reverse the home direction if it is desirable due to the layout of the system, etc.
(Note) Since the home position is adjusted at the factory before shipment, you must return your actuator to
IAI for adjustment if you wish to change the home direction after the delivery of your actuator.