Ransburg No. 2 Air Motor Atex Approved Unit 80086-XX User Manual

Page 48

AH----12

12----01.03 No. 2 Air Motor Handgun

01.03 No. 2 Air Motor Handgun

General Problem

Possible Causes

Solution

Electrical

No High Voltage Output

1. Power line unplugged

1. Plug in and verify available voltage.

2. Fuse(s) blown

2. See “Maintenance” section to replace

fuse(s).

3. High voltage cable failure; cable

3. High voltage cable failure; cable
crackles when system is on.

crackles when system is on.

3. Verify cable braid continuity from the con-

3. Verify cable braid continuity from the con-
nector end to the opposite end with ohm me-

nector end to the opposite end with ohm me-

nector end to the opposite end with ohm me-
ter. Replace as required.

ter. Replace as required.

Mild Shock When Picking Up

Mild Shock When Picking Up
Applicator by the Handle

Applicator by the Handle

1. Operator holding applicator by the

1. Operator holding applicator by the
barrel

barrel

1. Keep one bare had on the handle at all

1. Keep one bare had on the handle at all
times to ensure ground to the operator.

times to ensure ground to the operator.

2. Gun and power supply not ground-

2. Gun and power supply not ground-
ed

2. Ground power supply to true earth ground.

3. Operator wearing gloves; operator

3. Operator wearing gloves; operator
wearing rubber soled shoes

wearing rubber soled shoes

3. Remove rubber gloves or cut holes in the

3. Remove rubber gloves or cut holes in the
palm of the glove where handle contact can

palm of the glove where handle contact can

palm of the glove where handle contact can
be achieved. Add grounding straps to shoes if

be achieved. Add grounding straps to shoes if

be achieved. Add grounding straps to shoes if
required.

required.

4. Operator is charged before picking

4. Operator is charged before picking
up the applicator

up the applicator

4. Ensure operator has proper ground.

5. Metal shiel on high voltage cable is

5. Metal shiel on high voltage cable is
broken

broken

5. Verify cable braid continuity from the con-

5. Verify cable braid continuity from the con-
nector end to the opposite end with ohm me-

nector end to the opposite end with ohm me-

nector end to the opposite end with ohm me-
ter. Replace as required.

ter. Replace as required.

TROUBLESHOOTING