Teledyne 6200A - Sulfides analyzer - Manual (Page 62)

TAI Model 6200A SO
2
Analyzer Operator Manual, 02164, Rev. G
Figure 4-2: Front Panel Display
4.2.5.2 Status LED's
At the right of the display there are 3 status LED's. They can be in three states, OFF, ON, and
Blinking. The meanings of the LED's are given in Table 4-2.
Table 4-2: Front Panel Status LED's
LED State Meaning
Green Off
On
Blinking
NOT monitoring, DAS Disabled or inactive
Monitoring normally, taking DAS data
Monitoring, DAS in HOLDOFF mode (1)
Yellow Off
On
Blinking
Auto cal. disabled
Autocal. Enabled
Calibrating
Red Off
Blinking
Warnings exist
No warnings exist
(1) This occurs during Calibration, DAS holdoff, Power-up Holdoff, and when
in Diagnostic mode.
4-7