Teledyne 6200A - Sulfides analyzer - Manual (Page 105)

TAI Model 6200A SO
2
Analyzer Operator Manual, 02164, Rev. G
6.8.8 VARIABLES Commands and Messages
Table 6-16: RS-232 Operating Modes
Mode Description
ZERO CAL A Automatic zero calibration
ZERO CAL R Remote zero calibration
ZERO CAL M Manual zero calibration
SPAN CAL A Automatic span calibration
SPAN CAL R Remote span calibration
SPAN CAL M Manual span calibration
M-P CAL Manual multi-point calibration
DIAG ELEC Electrical diagnostic test
DIAG OPTIC Optical diagnostic test
DIAG AOUT D/A output diagnostic test
DIAG Main diagnostic menu
DIAG I/O Signal I/O diagnostic
DIAG RS232 RS232 output diagnostic
DIAG ERASE Memory erase diagnostic
SETUP x.x Setup mode (x.x is software version)
SAMPLE A Sampling; automatic cal. enabled
SAMPLE Sampling; automatic cal. disabled
The 6200A operational modes are listed above. To list the analyzer's current mode type:
V MODE Lists 6200A current operational mode
See Table 6-14 for list of operational modes and meanings.
Model 6200A Internal Variables
The 6200A has a number of internal setup variables. Essentially all of these are set at time of
manufacture and should not need to be changed in the field. A list of user accessible variables is
shown in Table 9-5.
6-24