Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller Installation User Manual
Page 47
The "keys" are a special datatype which can be displayed or configured as any other datatype with
the Hand Held Configurer. The "keys" are datapoint Q1 for front panel configuration and Q2 for
front panel F-CIM program access.
The value assigned to a "key" can be any ASCII string up to 10 characters. However, front panel
password entry will only permit numbers (0-9) as input characters. To remove a "key" completely,
modify its value to
3.3.1.5 STORAGE CARTRIDGE TRANSFER
The procedure for saving or loading the database program or calibration constants of an instru-
ment to/from a storage cartridge is as follows. First insert the cartridge containing the desired data-
base and/or program into the HHC. The cartridge is inserted by placing it into the recess at the
back of the HHC with the cartridge label facing outward and up, then sliding the cartridge down un-
til it is firmly seated. When loading to the instrument, verify that the write protect switch (when pre-
sent) on the cartridge has been pushed to its outside position. When saving to the cartridge the
write protect switch must be toward the inside.
To initiate the transfer operation press "T" at command entry point. The following menu will appear:
MEMORY TRANSFER
F1-TO CONTROLLER
F2-FROM CONTROLLER
PRESS EITHER F1 or F2 key to select the desired operation. Pressing
eration. Depending on which selection is made one of the following two menus will be displayed:
1. If F1 is selected, the following menu will appear:
F1-CALIBRATE
F2-DATABASE
F3-PROGRAM
Based on which selection from this menu is made the following operations will occur:
F1-CALIBRATE:
This copies the calibration values of the standard analog inputs and outputs to the
controller. These values were saved to the storage cartridge during the copying of
the database to the cartridge. Transfer takes approximately 1 second.
F2-DATABASE:
This copies the database less the calibration values and the instrument address to
the controller. Transfer takes approximately 12 seconds.
F3-PROGRAM:
This copies the user programs and F-CIM program which were earlier saved to the
controller. Transfer takes approximately 20 seconds.
MODULAR CONTROLLER QUICK START
3-22