Luminex MAGPIX Hardware and Installation Manual - Manual (Page 43)

1. Plug the power cord from the back of the instrument into a power outlet.
NOTE: Luminex recommends the use of a surge protector or UPS device
with MAGPIX. For more information, see Uninterruptible Power
Supply (UPS) or Surge Protector on page 54.
2. Turn on the hard power switch (1). This is the toggle switch at the lower right corner of
the back of MAGPIX.
NOTE: The hard power switch controls flow of power to the instrument.
FIGURE 34. The Hard Power Switch
MAGPIX ®
30