Installing the drive fluid – Luminex MAGPIX Hardware and Installation Manual User Manual
Page 38
5. Reinstall the probe fitting, tightening it until it clicks into place.
FIGURE 27.
The Sample Probe in Position
6. Close and latch the side access door.
Installing the Drive Fluid
The overpack includes a carton containing two containers of Drive Fluid. Open the carton and
remove one container to install in the instrument.
To install the Drive Fluid container:
Installation Procedure
25
See also other documents in the category Luminex Equipment:
- FLEXMAP 3D User Manual (86 pages)
- MAGPIX User Quick Guide (29 pages)
- xMAP Antibody Coupling Kit (24 pages)
- xMAP AbC (2 pages)
- Salmonella Analysis Tool (8 pages)
- 200 Hardware User Manual (70 pages)
- FLEXMAP 3D Hardware User Manual (72 pages)
- 100E Hardware User Manual (38 pages)
- 200 System User Manual (63 pages)
- 100 IS 2.2 User Installation Guide (10 pages)
- 200 Installation Guide (52 pages)
- 100 IS 2.1 User Installation Guide (10 pages)
- No Top Plate (NTP) Swivel Base Installation and User Manual (18 pages)
- 100 IS 2.3 User Installation Guide (10 pages)
- MAGPIX Installation and Hardware User (IVD) (88 pages)
- PC Installation Instructions (2 pages)
- BioPlex XYP, LX200 User Manual (supplied by BioRad) (51 pages)
- 100 IS User Manual, Version 2.1 (184 pages)
- 100 IS User Manual, Version 2.1 (188 pages)
- 100 IS User Manual, Version 2.3 (228 pages)
- 100 IS Version 2.1 (84 pages)
- 100 IS Version 2.3 (230 pages)
- 100 IS Version 2.2 (96 pages)
- 100 IS Version 2.2 (246 pages)
- 100 IS Developer Workbench Guide Version 2.3 (74 pages)
- IS Version 2.3 (120 pages)
- IS Version 2.3 (IVD) (116 pages)
- 100 User Manual Version 1.7 (146 pages)
- 200 User Manual with LDS 1.7 Software (154 pages)
- 200 LDS User Manual Update (10 pages)
- Flock Monitor Quick Guide (2 pages)
- 200 User Manual with IS 2.3 Software (64 pages)
- 100 User Manual Addendum Version 1.7 (12 pages)
- 100 IS User Manual Addendum Version 2.3 (58 pages)