Powering up magpix – Luminex MAGPIX Hardware and Installation Manual User Manual

Page 42

7. Slide the container into the tray on the left side of the fluid compartment. The container

tray is constructed to hold the container in place.

FIGURE 33.

Sliding in the Drive Fluid Container

8. After the container is fully inserted, check the valve on the front of the waste fluid

container to make certain it is securely attached and close the door of the fluid
compartment.

Powering Up MAGPIX

MAGPIX has two on/off switches: a hard power switch and a soft power switch.

To power on MAGPIX:

Installation Procedure