GF Signet 8150 Battery-Powered Flow Totalizer - Manual (Page 13)

13 8150 Flow Totalizer
13. Decimal Point for Flow Display
Select the maximum decimal resolution for the fl ow rate display.
The available selections are hundredths (xx.xx), tenths (xxx.x) or
whole numbers only (xxxx.). The decimal will auto-range down to
this setting.
• If the decimal is set to whole numbers, the fl ow rate display will
not auto-range.
• If the decimal is set to tenths, the fl ow rate display will show
tenths up to 999.9, then the auto-range will switch to whole
numbers (1000 to 9999.)
• If the decimal is set to hundredths, the fl ow rate display will show
hundredths up to 99.99, then tenths from 100.1 to 999.9, then
whole numbers to 9999.
Example: Change the maximum decimal display from
hundredths to tenths:
1. Hold the ENTER key for 2 seconds, then enter the
SECURITY CODE.
The display shows the fi rst item in the menu, AutoCAL.
2. Press the ▼ key four times to scroll to the Decimal setting.
The display shows four dashes and the current decimal
setting.
3. Press the ► key to select the decimal for editing.
The decimal point will begin to fl ash.
1
6
2 3 4 5
2 s
4x
Enter Security code
*
**
4. Press the ▼ key one time to move the fl ashing decimal from
hundredths to tenths.
5. Press the ENTER key to return to the menu.
The decimal will stop fl ashing.
6. Press ▲ and ▼ keys together to exit the menu and return to
normal operation.
The display shows "Storing" for a few seconds, then returns
to the normal operating display.
Press the ▲ and ▼ keys simultaneously from
the main menu to return to normal operation. As long as any element is fl ashing, you can abort
the change and return to the original value by
pressing ▲ and ▼ keys simultaneously.
Exit Without Changing? * Finished Editing?
**
Available Display
Selections
Your Flow
rate
will read on
display as:
hundredths (XX.XX) 10.55 10.55
tenths (XXX.X) 10.55 10.6
whole numbers (XXXX.) 10.55 11