Burkert Type 8056 - Manual (Page 54)

- 54 - RS232_485_ETP_MODBUS_BU_REV02.doc
Set command: DLTTI= n 0:OK if parameters accepted
1:CMD ERR if logging functions not
enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
Help command: DLTTI=?
min <> max (units) if accepted
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
Read command: DTSON? Status of operation if accepted
5:ACCESS ERR if insufficient access
level
Set command: DTSON=1 0:OK if parameters accepted
2:PARAM ERR if
n not equal to 1
3:EXEC ERR if operation not possible
5:ACCESS ERR if insufficient access
level
DTSON (Data logger Test Start
ON) Starts the “step check” test
mode and reads the status of the
operation (1 = in progress , 0 =
terminated). If the stop date is less
than the current time and date, an
error code is returned
Help command: DTSON=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED 1:CMD ERR if command is issued
Set command: DTSOF=1 0:OK if parameters accepted
2:PARAM ERR if n not equal to 1
5:ACCESS ERR if insufficient access
level
DTSOF (Data logger Test Start
OFf) Stops or suspend the “step
check” test mode.
Help command: DTSOF=?
1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “10-DIAGNOSTIC” MENU
Name and description Modes Returned values or codes
Read command: CALIC?
Status of calibration operation if
accepted
Set command: CALIC=1 0:OK if parameters accepted
2:PARAM ERR if n not equal to 1
CALIC (CALibration Immediate
Command) performs an immediate
calibration cycle and reads the
status of the operation (1 = in
progress , 0 = terminated).
Help command: CALIC=?
1:EXECUTE if accepted
Read command: NOT
SUPPORTED 1:CMD ERR if command is issued
Set command: ATSIC=1 0:OK if parameters accepted
2:PARAM ERR if n not equal to 1
5:ACCESS ERR if insufficient access
level
ATSIC (Auto-TeSt Immediate
Command) Performs an auto-test
cycle.
Help command: ATSIC=?
1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
MSIEN (Measure SImulation
ENable) Enables or disables the
measure simulation function.
Read command: MSIEN?
Status of measure sim. function if
accepted
5:ACCESS ERR if insufficient access
level