Burkert Type 8056 User Manual
Page 39

- 39 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Read command: EPDAT?
Value of empty pipe threshold if
accepted
5:ACCESS ERR if insufficient access
level
Set command: EPDAT=
n
0:OK if parameters accepted
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
EPDAT (Empty Pipe Detection
Alarm Threshold) Reads or sets the
value of the alarm threshold for the
empty pipe detection system.
Help command: EPDAT=?
min <> max (units)
if accepted
5:ACCESS ERR if insufficient access
level
Read command: OCACV?
Value of alarm current output if
accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level
Set command: OCACV=
n
0:OK if parameters accepted
1:CMD ERR if current output not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
OCACV (Output Current Alarm
Condition Value) Reads or sets the
value of the alarm value at which
the current output will be set in
case of error conditions. Valid only if
the current output is installed and
enabled.
Help command: OCACV=?
min <> max (units)
if accepted
1:CMD ERR if current output not
enabled .
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “5-INPUTS” MENU
Name and description
Modes
Returned values or codes
Read command: VTTPE?
Status of reset consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Set command: VTTPE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
VTTPE (Volume Totalizer Total
Positive reset Enable) Enables or
disables the consent for resetting
the total positive volume totalizer
when receiving an external signal
on the digital input. Valid only if
the digital input is installed and
enabled.
Help command: VTTPE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
VTPPE (Volume Totalizer Partial
Positive reset Enable) Enables or
disables the consent for resetting
the partial positive volume totalizer
when receiving an external signal
Read command: VTPPE?
Status of reset consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level