Burkert Type 8056 User Manual
Page 51

- 51 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: DLDRE=?
1:EXECUTE
if accepted
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
Read command: DLDSE?
Status of static data send if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: DLDSE=
n
0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
DLDSE (Data Logger static Data
Send Enable) Enables or disables
the sending of the static data
logger’s data by email using the
GPRS terminal.
Help command: DLDSE=?
List of
num:description
if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read number of records:
DLYRD?
Number of records in memory if
accepted
1:CMD ERR if logging functions not
enabled
Read record: DLYRD=
n
Record
n
in CSV format if accepted
1:CMD ERR if logging functions not
enabled
2:PARAM ERR if
n
out of range
DLYRD (Data Logger dYnamic
ReaD) Reads the specified record,
the number of records saved in the
dynamic data logger or the
maximum number of records that
can be saved in memory.
Read max capacity:
DLYRD=?
Maximum range of
n
for the memory
in the format
min <> max
if
accepted
1:CMD ERR if logging functions not
enabled
Read command: NOT
SUPPORTED
1:CMD ERR if command is issued
Set command: DLYRE=1
0:OK if parameters accepted
1:CMD ERR if logging functions not
enabled 2:PARAM ERR if
n
not equal
to 1
5:ACCESS ERR if insufficient access
level
DLYRE (Data Logger dYnamic
REset) Resets the dynamic data
logger and clears all records.
Help command: DLYRE=?
1:EXECUTE
if accepted
1:CMD ERR if logging functions not
enabled .
5:ACCESS ERR if insufficient access
level
Read command: DLYSE?
Status of dynamic data send if
accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
DLYSE (Data Logger dYnamic
Send Enable) Enables or disables
the sending of the dynamic data
logger’s data by email using the
GPRS terminal.
Set command: DLYSE=
n
0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level