Burkert Type 8056 User Manual
Page 41

- 41 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: TCLIE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: CALIE?
Status of calibration consent if
accepted
1:CMD ERR if digital input not
enabled
Set command: CALIE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
CALIE (CALibration Input Enable)
Enables or disables the consent for
calibrating when receiving an
external signal on the digital input.
Valid only if the digital input is
installed and enabled.
Help command: CALIE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: SRCIE?
Status of range change consent if
accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Set command: SRCIE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
SRCIE (Scale Range Change
Input Enable) Enables or disables
the consent for changing the scale
range when receiving an external
signal on the digital input. Valid
only if the digital input is installed
and enabled.
Help command: SRCIE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: WKUIE?
Status of wake-up consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Set command: WKUIE =
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
WKUIE (WaKe-Up Input Enable)
Enables or disables the consent for
waking-up from the energy saving
standby mode when receiving an
external signal on the digital input.
Valid only if the digital input is
installed and enabled.
Help command: WKUIE
=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “6-OUTPUTS” MENU