Burkert Type 8056 - Manual (Page 38)

- 38 - RS232_485_ETP_MODBUS_BU_REV02.doc
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “4-ALARMS” MENU
Name and description Modes Returned values or codes
Read command: FRAXP?
Value of positive max threshold if
accepted
5:ACCESS ERR if insufficient access
level
Set command: FRAXP= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRAXP (Flow Rate Alarm maX
Positive threshold) Reads or sets
the value of the maximum positive
flow rate alarm threshold.
Help command: FRAXP=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: FRAXN?
Value of negative max threshold if
accepted
5:ACCESS ERR if insufficient access
level
Set command: FRAXN= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRAXN (Flow Rate Alarm maX
Negative threshold) Reads or sets
the value of the maximum positive
flow rate alarm threshold.
Help command: FRAXN=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: FRANP?
Value of positive min threshold if
accepted
5:ACCESS ERR if insufficient access
level
Set command: FRAXP= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRANP (Flow Rate Alarm miN
Positive threshold) Reads or sets
the value of the minimum positive
flow rate alarm threshold.
Help command: FRAXP=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: FRANN?
Value of negative min threshold if
accepted
5:ACCESS ERR if insufficient access
level
Set command: FRANN= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRANN (Flow Rate Alarm miN
Negative threshold) Reads or sets
the value of the minimum positive
flow rate alarm threshold.
Help command: FRANN=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: ATHYS?
Value of hysteresis if accepted
5:ACCESS ERR if insufficient access
level
Set command: ATHYS= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
ATHYS (Alarm Thresholds
HYSteresis) Reads or sets the value
of the alarm threshold hysteresis.
Help command: ATHYS=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level