Burkert Type 8056 - Manual (Page 42)

- 42 - RS232_485_ETP_MODBUS_BU_REV02.doc
Name and description Modes Returned values or codes
Read command: OUT1F? Type of function if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
Set command: OUT1F= n 0:OK if parameters accepted
1:CMD ERR if digital outputs not
enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
OUT1F (OUTput 1 Function) Sets
the function type related to the
digital output 1. Valid only if the
digital outputs are installed and
enabled.
Help command: OUT1F=?
List of num:description if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
Read command: OUT2F?
Type of function if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
Set command: OUT2F= n 0:OK if parameters accepted
1:CMD ERR if digital outputs not
enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
OUT2F (OUTput 2 Function) Sets
the function type related to the
digital output 2. Valid only if the
digital outputs are installed and
enabled.
Help command: OUT2F=?
List of num:description if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
Read command: OUTIS?
Type of function if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
Set command: OUTIS= n 0:OK if parameters accepted
1:CMD ERR if digital outputs not
enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
OUTIS (OUT Immediate State)
function for set in direct way the
value of the digital outputs
Help command: OUTIS=?
List of num:description if accepted
1:CMD ERR if digital outputs not
enabled
5:ACCESS ERR if insufficient access
level
CO1FS (Current Output 1 Full
Scale) Sets the full scale value for
the current output 1: it can be 20
or 22 mA. Valid only if the current
output1 is installed and enabled.
Read command: CO1FS?
Full scale value if accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level