Burkert Type 8056 User Manual
Page 53
- 53 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: DLMRE=?
1:EXECUTE
if accepted
1:CMD ERR if logging functions not
enabled .
5:ACCESS ERR if insufficient access
level
Read command: DLUSE?
Status of measure units send if
accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: DLUSE=
n
0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
DLUSE (Data Logger measure
Units Send Enable) Enables or
disables the sending of the
measure units of the loggers data
by email using the GPRS terminal.
Not enabling this option makes the
data more compact to send by
wireless communication.
Help command: DLUSE=?
List of
num:description
if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: DLTST?
Value of date and time if accepted
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
Set command:
DLTST=
tmstring
Required access level: 2
Value of date and time set
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
DLTST (Data Logger Test Start
Time) Reads or sets the date and
time start value used for the “step
check” test. WARNING: when
setting the date and time,
always check the value
returned because malformed
input string may lead to
incorrect time result.
Help command: DLTST=?
Format of the string to be input
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
Read command: DLTPT?
Value of date and time if accepted
1:CMD ERR if logging functions not
enable
5:ACCESS ERR if insufficient access
level
Set command:
DLTPT=
tmstring
Value of date and time set
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
DLTPT (Data Logger Test stoP
Time) Reads or sets the date and
time stop value used for the “step
check” test. WARNING: when
setting the date and time,
always check the value
returned because malformed
input string may lead to
incorrect time result.
Help command: DLTPT=?
Format of the string to be input
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level
DLTTI (Data Logger Test Time
Interval) Reads or sets the time
interval used for the “step check”
test. The time is in minutes.
Read command: DLTTI?
Value of time interval if accepted
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level