Burkert Type 8056 - Manual (Page 52)

- 52 - RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: DLYSE=? List of num:description if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read number of records:
DLERD? Number of records in memory if
accepted
1:CMD ERR if logging functions not
enabled
Read record: DLERD= n Record n in CSV format if accepted
1:CMD ERR if logging functions not
enabled
2:PARAM ERR if
n out of range
DLERD (Data Logger Event ReaD)
Reads the specified record, the
number of records saved in the
event data logger or the maximum
number of records that can be
saved in memory.
Read max capacity:
DLERD=? Maximum range of n for the memory
in the format min <> max if
accepted
1:CMD ERR if logging functions not
enabled
Read command: NOT
SUPPORTED 1:CMD ERR if command is issued
Set command: DLERE=1 0:OK if parameters accepted
1:CMD ERR if logging functions not
enabled 2:PARAM ERR if
n not equal
to 1
DLERE (Data Logger Event REset)
Resets the events logger and clears
all records.
Help command: DLERE=?
1:EXECUTE if accepted
1:CMD ERR if logging functions not
enabled .
Read command: DLESE?
Status of events data send if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: DLESE= n 0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
DLESE (Data Logger Events Send
Enable) Enables or disables the
sending of the events data logger’s
data by email using the GPRS
terminal.
Help command: DLESE=? List of num:description if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: DLMRD? Min/max values in CSV format if
accepted
1:CMD ERR if logging functions not
enabled
Set command: NOT
SUPPORTED
1:CMD ERR if command is issue
DLMRD (Data Logger Min/max
ReaD) Reads the min/max stored
values.
Help command: NOT
SUPPORTED 1:CMD ERR if command is issued
Read command: NOT
SUPPORTED 1:CMD ERR if command is issued DLMRE (Data Logger Min/max
REset) Resets the min/max stored
values.
Set command: DLMRE=1 0:OK if parameters accepted
1:CMD ERR if logging functions not
enabled
5:ACCESS ERR if insufficient access
level