Extron Electronics VN-MATRIX User Guide - Manual (Page 48)

Section 3: System Configuration VN-MATRIX User Guide
Page 48 I458GB issue 6
Additional Setup for Audio
Additional Information for Encoder Setup
o
Click the audioPort0 icon.
The Configure page will appear…
n
Click the Device tab to
return to the Device page…
p
Check that the Audio Status shows a valid
audio source type. If not, see page 50.
q
Ensure that Compression is set
to no compression.
For further information on this feature, see page 73.
r
Tick the Multicast Enable box if RTP Multicast
source streaming is required, otherwise ensure
this box is unticked to enable RTP Unicast.
This must be the same as the videoPort setting.
s
Encoder setup is now complete, click the tab.
Repeat this procedure (from page 46, step n ) for each encoder in the system.
To configure a VN-MATRIX device as a decoder (display), turn to page 51.