Extron Electronics VN-MATRIX User Guide - Manual (Page 35)

VN-MATRIX User Guide Section 2: Installation & Basic Setup Procedures
I458GB issue 6 Page 35
Connections
Supplied Cables
A set of cables is supplied with VN-MATRIX to accommodate a variety of standard connection
requirements.
The VN-MATRIX is compatible with both digital (DVI) and analog graphics signals. The unit is
provided with the necessary additional cables that you may require.
Source (encoder) Display (decoder) Cable Description
Digital Analog Digital Analog
Mouse/Keyboard Cable (PS/2 to PS/2) (2 off)
Digital Monitor Cable (DVI-D to DVI-D)
Analog Monitor Cable (15-pin Hi-D D-type to DVI-A)
DVI-A to 15-pin Hi-Density D-type Adapter
For Connection Diagram see page… 37 38 39 40
IMPORTANT NOTES
Disconnecting and reconnecting PS/2 cables to a computer that is already switched on may cause
loss of mouse/keyboard control or cause the computer to ‘freeze’. It is recommended, therefore, that
the connections are made while the computer is powered-down. See also ‘Power-up Procedure’ on
page 28.
If you use a monitor cable or adapter other than that provided with the VN-MATRIX (as an encoder)
you must ensure that all pins are properly interconnected, otherwise the computer graphics card or
monitor may not operate correctly.