Extron Electronics VN-MATRIX User Guide - Manual (Page 19)

VN-MATRIX User Guide Section 1: Introduction
I458GB issue 6 Page 19
Front Panel Features
NETWORK II
STATUS
NETWORK I
POWER
ELECTROSONIC
Indicators
The following indicators are visible on the front of the VN-MATRIX:
Name Color Function
POWER Green Fully Lit – when the unit is receiving power from the 12V supply input.
Flashing – an over temperature condition has occurred or there was a
power overload/underload condition. Cycle the power off/on to reset.
NETWORK I Orange Indicates the status of network port I:
Fully Lit or Flashing Intermittently – control or source data is being
transmitted or received by the port.
Unlit – no data or no network connection detected.
NETWORK II Orange Indicates the status of network port II:
Fully Lit or Flashing Intermittently – control or source data is being
transmitted or received by the port.
Unlit – no data or no network connection detected.
STATUS Green Indicates the source status of the VN-MATRIX:
Condition Encoder (source) Decoder (display)
Unlit No source input detected No source being received
Flashing Source being streamed Source being received
Fully Lit Source present but not
being streamed (e.g. unit
currently disabled or in
standby mode) n/a
NOTE: During the VN-MATRIX boot up period (typically 20-30 seconds) the NETWORK and STATUS
indicators may light up or flash intermittently while the unit initializes.
Reset Button
VN-MATRIX is fitted with a concealed reset button. This can be used to reboot the operating system,
for example during firmware upgrade procedures.
To activate this button, insert the blade of a very small screwdriver (or similar tool) or straightened
paper clip into the hole on the front panel, on the left of the indicators.