Canon Prima Super 28N -Set - Manual (Page 83)

Troubleshooting
Before taking your camera to be repaired, check the table
below. If your camera does not function properly even after
making these checks, take it to your nearest Canon service
center.
83
Problem
1. The battery
check
mark
blinks.
2. Does not
function
even if the
battery
check mark
is not
displayed.
3. The shutter
does not
release.
4. The pic-
tures are
blurry.
5. “E” is dis-
played on
the LCD
panel.
Cause
The battery has expired.
1. No battery loaded.
2. The battery is inserted
with the wrong polari-
ty.
3. The battery has com-
pletely expired.
1. The lens cover is not
open.
2. The battery has
expired.
3. The film is not loaded
properly.
4. A finished film is
loaded in the camera.
5. The shutter releases
after the red-eye
reduction lamp is lit.
1. When the shutter was
released, the AF light
emitter and receiver
were blocked.
2. During self-timer pho-
tography, you pressed
the shutter button
while standing imme-
diately in front of the
camera.
3. The camera was
moved when the shut-
ter button was
pressed (camera
shake).
This is a self-diagnosis
display when reset is
necessary.
Remedy
Change the battery.
1. Load a battery.
2. Reinsert the battery cor-
rectly.
3. Replace the battery.
1. Open the lens cover to
turn on the power.
2. Replace the battery.
3. Reload the film correctly.
4. Remove the film and
load a new one.
5. Keep pressed until the
shutter is released.
Change the flash mode.
1. Make sure the AF light
emitter and receiver are
not blocked by hair, fin-
gers, etc.
2. Make sure you are not
standing directly in front
of the camera.
3. Press the shutter button
gently.
Open then close the lens
cover. (If the display
remains, take the camera
to be repaired.)
Page
26
26
26
26
28
26
38
38
80
70
33
69
34
28
005-Sure Shot Z70W p.82-95.qx 15-10-2002 10:47 Pagina 83