Asus GigaX2124 - Manual (Page 91)

79
Chapter 5 - Command Line Interface
5.3.6 Spanning Tree
5.3.6.1 show spanning-tree summary
Show spanning-tree active.
CLI Syntax: show spanning-tree summary
Example: ASUS# show spanning-tree summary
5.3.6.2 spanning-tree enable and disable
Enable/Disable the spanning tree.
CLI Syntax: spanning-tree (enable | disable)
Example: (config)# spanning-tree disable
5.3.7 Link Aggregation
5.3.7.1 trunk aggregation group
Use the aggregation-link trunk group configuration command on the switch
to configure trunk aggregation group.
CLI Syntax: aggregation-link group <1-8> IFLIST
Example: (config)# aggregation-link group 1 gi1/0/1-3
5.3.7.2 trunk load balancing
Use the aggregation-link trunk group configuration command on the switch
to configure trunk load balancing by using source-based or destination-
based forwarding methods.
CLI Syntax: aggregation-link group <1-8> load-balance (src-mac |
dst-mac | src-dst-mac | src-ip | dst-ip | src-dst-ip)
Example: ASUS# aggregation-link group 1 load-balance src-mac