Asus GigaX2124 - Manual (Page 20)

8
Chapter 3 - Quick Start
ASUS GigaX2124
3 Quick Start
This section provides the basic instructions to set up the GigaX
environment. Refer also to the GigaX212 4 Installation Guide.
Part 1 shows you how to install the GigaX on a flat surface or on a rack.
Part 2 provides instructions to set up the hardware.
Part 3 shows you how to configure basic settings on the GigaX.
Before starting, obtain the following information from your network
administrator:
• IP address for the switch
• Default gateway for the network
• Network mask for this network
3.1 Part 1: Installing the switch
The switch can be installed either on a flat surface or on a rack.
3.1.1 Installing on a flat surface
The switch should be installed on a flat surface which can support the
weight of the switches and their accessories. Attach four rubber pads on
the four indented circles located at the bottom of the switch. See illustration
below.
1
2
3
4
Indented circles 1, 2, 3, & 4.
Attach rubber pads here.