Draw-Tite 30035 FIFTH WHEEL RAILS User Manual
Page 5
Chevy and GM 2011 and Newer, 2500 HD & 3500 HD Silverado and Sierra
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the ~4” between parallel rows of
spot welds where the bed sill sits.
R
O
W
1
R
O
W
2
R
O
W
4
R
O
W
3
Front of
Vehicle
Rear Edge of
Truck Bed
Measure from rear edge of
truck bed to rear edge of
base rail
NOTE:
Must install center bolt in
one of the center holes in
each rail.
8’ BOX: 29 ¾”
6’ BOX: 25 ¼”
NOTE: For ease of
installation, installer can
use ½” 13, grade 5 Hex
head bolt and flat
washer.
z 2006,2007,2008,2009,2010,2011,2012,2013 Cequent Performance Products, Inc.
Made in China
30035IN
9/4/13
Rev. R
*
Optional weld
pattern
Drivers side of 3/4 ton HD shown
Long bracket
Side Bracket
Short bracket
1/4 2
1/4 2
*
1/4 1.5-3
1/4 2
*
King pin centered over Axle
Long Box Bed Sills
Short Box and some year
Long Box Bed Sills
Front of
Vehicle
SHEET 4 0F 21
Note: Pull wires provided, will be needed to install
hardware in brackets through frame.
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
each rail.
Check to make sure center
bolt does not interfere with
bed sill.