Draw-Tite 65008 FRONT MOUNT RECEIVER - Manual

Receiver Shown In Proper Position
Bumper
Front Mounted Receiver
Installation Instructions
Jeep Grand Cherokee
Part Numbers:
65008
1. If present, remove steel skid shield and return to vehicle owner. If present, remove plastic underbody panel and return to
vehicle owner.
2. Remove the forward attachment bolts in the vehicle crossmember.
3. Raise receiver into position and fasten as shown above.
Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft (52 N-m).
Rev. A 11-07-05 N65008 Sheet 1 of 3 z 2005 Cequent Towing Products
Conical Washer, 7/16” Qty. (6) 2 Hex Bolt, M10 x 1.50 x 30 Qty. (6) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000
Equipment Required:
Wrenches: 15mm, 16mm
Drill Bits: None
Fastener Kit: K65008
Frame
Existing Weldnuts
Remove Existing
Fastener
Vehicle Crossmember
Recovery Eye