Draw-Tite 65021 FRONT MOUNT RECEIVER - Manual

Bumper
Lower Fascia
(Optional)
OEM Tow Hook (Optional)
May Need To Be Drilled
On Some Vehicles
Front Mounted Receiver
Installation Instructions
Chevy/GMC Pickup & Suburban
2500 & 3500 Series – 2WD Only
8600# GVW And Higher (8 Lug Wheels)
Part Numbers:
65021
* Use with optional OEM tow hook.
1.
If present, remove lower fascia under bumper.
2. If present, remove vehicle tow hooks.
3. Feed the fasteners shown above through end of frame with pull wire.
4. Raise hitch into position and attach fasteners and tow hooks as shown above.
5. If large slot is not present, drill a 1/2" hole using the hitch as a template.
6. If desired, trim and reinstall the lower fascia. CONSULT VEHICLE OWNER BEFORE TRIMMING.
Rev. A 11-07-05 N65021 Sheet 1 of 3 z 2005 Cequent Towing Products
Pull Wire, 1/2” Qty. (2) 6 Spacer, 1-1/2” x 2” x 1/4” Qty. (6) 3
Hex Nut, 1/2” Qty. (6) 5 Carriage Bolt, 1/2”-13 x 2-1/4” Qty. (4) 2
Conical Washer, 1/2” Qty. (6) 4 Carriage Bolt, 1/2”-13 x 1-3/4” Qty. (6) 1
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Equipment Required:
Wrenches: 10mm, 18mm, 7/8”
Drill Bits: 1/2”
Fastener Kit: 01131-060
Receiver Shown In Proper Position
Hitch Requires 5/8” Pin and Clip
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000