Draw-Tite 30035 FIFTH WHEEL RAILS - Manual (Page 16)

DODGE (RAM) ‘03-12’ 2500 AND 3500 WITH OVERLOAD BRACKETS
(REQUIRES 58186 BRACKET KIT )
28-5/16” Long Box
26-5/16” Short Box
Front
of
Vehicle
Rear Edge of
Truck Bed
Drill through
Bed Sill with
17/32” drill.
Open up hole
through truck
bed only with
1” dia. drill.
Drop tube
spacer
through hole
in truck bed to
avoid crushing
Bed Sill when
torquing 4-1/2”
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Tube spacers and 4 1/2” carriage bolts used to attach through rearward Bed Sill (Row 3).
2. **Rib neck bolts will need to be pulled through rearward access holes in frame with supplied pull wire (see below).
4. It is very important that
brackets in Row 2 are against
rear side of Bed Sill as shown.
Due to dimensional instability
in Bed Sill placement with the
Dodge truck, interference
could result when drilling in
Row 3. Observe caution note
below and double check all
areas prior to drilling.
5. Rear brackets can be
mounted to frame with (2)
bolts in any combination
of the three bracket holes.
6. *Due to tubular frames
having thinner walls than
previous C channel frames,
3. Do not drill thru both walls of
frame. Drill only thru wall of
frame to which bracket is
mounted.
Drill 2 center holes shown in
addition to 8 holes for 30035
kit. Install 1/2” carriage bolts,
slotted spacer above or below
bed to fill bed corrugation, and
bolt plate below bed with
washer and nut.
z 2006,2007,2008,2009,2010,2011,2012,2013 Cequent Performance Products, Inc.
Made in China 30035IN 9/4/13 Rev. R
26-5/16” Short Box
Side Bracket
*
Optional weld
pattern
Inside frame
King Pin Centered
over Axle Center
*
1/4 2
1/4 1.5-3
*
Use provided(30035 kit) tube
spacers and 4-1/2” carriage bolts
to attach through Bed Sill
torquing 4-1/2”
carriage bolt.
**Rearward access hole
(in top of frame)
Measure from Rear
Edge of truck bed to
rear edge of base rail.
Long bracket
Bed Sill
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
previous C channel frames,
extra caution needs to be
used when mounting with the
optional welding.
Drivers side of 2500 Ram Long box Shown
1/4 2
1/4 2
SHEET 15 0F 21
Front
of
Vehicle