Draw-Tite 65001 FRONT MOUNT RECEIVER - Manual

Access Point
For Fasteners
Enlarge Hole
Receiver Shown In Proper Position
Bumper
Front Mounted Receiver
Installation Instructions
Ford Econoline
Part Numbers:
65001
1. If present remove any plastic rivets from forward attachment on vehicle.
2. Enlarge forward hole on vehicle with a 1/2 drill bit.
3. Feed carriage bolts and block thru access point using a pull wire as shown.
4. Raise hitch into position and fasten as shown above.
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. A 10-31-05 N65001 Sheet 1 of 3 z 2005 Cequent Towing Products
Pull Wire Qty. (2) 5
Nut, 1/2” Qty. (4) 4 Spacer, 1/4” x 1” x 3” Qty. (4) 2
Conical Toothed Washer, 1/2” Qty. (4) 3 Carriage Bolt, 1/2”-13 x 1-3/4” Qty. (4) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000
Equipment Required:
Wrenches: 7/8”
Drill Bits: 1/2”
Fastener Kit: K65001