Draw-Tite 65063 FRONT MOUNT RECEIVER - Manual

Installation Instructions
Dodge RAM 2500/3500
w/ Factory Tow Hook Package
Part Numbers:
65063
Hitch Shown In Proper Position
Equipment Required: Tape
Wrenches: 11/16”, 17mm
Drill Bits: None
Note: During the installation, it is recommended to cover the edges of the fascia opening to protect the chrome/paint as shown in Figure 1.
1. Remove factory tow hooks and fasteners from vehicle, set tow hooks aside and return fasteners to customer.
2. Before raising hitch into position insert provided fasteners through tow hooks as shown in Figure 2.
3. Raise hitch into position and align with holes in tow hook mounting bracket.
4. Raise tow hook into position and insert fasteners through hitch brackets and into the tow hook mounting bracket.
5. On the reverse side of tow hook mounting bracket install fasteners as shown in Figure 3.
Tighten all M10 fasteners with torque wrench to 53 Lb.-Ft.
© 2013 Cequent Performance Products, Inc Sheet 1 of 3 65063N 1-10-13 Rev. A
j
Qty. (8) M10 X 1.50 X 60 CL 10.9 Hex Bolt
l
Qty. (8) M10 X 1.50 CL 10 Hex Nut
k
Qty. (16) 3/8” Conical Washer
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Fastener Kit: 65063F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Form: F205 Rev C 9-17-2012
CARGO CAPACITY – Do not exceed
500 LB. or Truck Front
Gross Axle Weight Rating, (GAWR).
9,000lb. MAXIMUM WINCH LINE PULL
Fascia
jkkl
Figure 2: OEM Tow Hook Assembly
Figure 3: Hitch Installation
Tow Hook
Mounting Bracket
Receiver Tube
Figure 1: Fascia Opening
Protect Perimeter
of Fascia Opening
Note: When attaching accessories make sure not to over insert shank into receiver tube, doing so may damage the radiator.