Draw-Tite 65003 FRONT MOUNT RECEIVER User Manual
Front mounted receiver installation instructions, Dodge ram, Part numbers
Existing Weldnut
Recovery Eye
Sway Bar
Bracket
Figure 2
Front Mounted Receiver
Installation Instructions
Dodge Ram*
Part Numbers:
65003
1.
If present, remove lower fascia.
2.
Lower sway bar brackets and return fasteners to vehicle owner.
3.
If present, remove any fastener in the forward attachment hole on vehicle.
4.
Raise receiver into position and reattach sway bar brackets placing the receiver between the frame and the sway bar bracket as shown in
Figure 2.
5.
Attach forward fasteners as shown in Figure 2.
NOTE: Bumper brackets may require repositioning to align with receiver mounting holes.
6.
If desired, trim lower fascia and reinstall. CONSULT VEHICLE OWNER BEFORE TRIMMING.
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. A
11-07-05
N65003
Sheet 1 of 3
z
2005 Cequent Towing Products
Conical Washer, 3/8”
Qty. (4)
6
Spacer, 2” x 1-1/2” x 1/4”
Qty. (2)
3
Hex Bolt, M10 x 1.5 x 35 CL10.9
Qty. (4)
5
Conical Washer, 1/2”
Qty. (4)
2
Nut, M12 x 1.75
Qty. (2)
4
Hex Bolt, M12 x 1.75 x 45 CL10.9
Qty. (2)
1
Tighten all M10 CL10.9 fasteners with torque wrench to 35 Lb.-Ft (47 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL
9000
* NOTE: 1999 “Sport Model” vehicles require extensive fascia cut. See Figure 1.
CONSULT VEHICLE OWNER BEFORE TRIMMING.
Equipment Required:
Wrenches: 15mm, 16mm, 18mm,
T-30 Torx
®
Driver
Fastener Kit: 01131-016
Receiver Shown In Proper Position
Bumper
Lower
Fascia
Area to cut
1999 Sport Model Fascia
Figure 1
Drill Bits: None