Draw-Tite 30035 FIFTH WHEEL RAILS - Manual (Page 11)

Ford ‘97 to ’03 F-150 & F-250 8500 GVW AND UNDER and ’04 Heritage Series Body Style
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Long and Short Brackets on Driver’s Side may need to be switched to avoid interference with exhaust hanger.
2. May need to move base rail location +/- 1/2” to ensure frame brackets do not interfere with bed sills.
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
29-1/4” Long Box
and Short Box
Front
of
Vehicle
Rear Edge of
Truck Bed
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
NOTE:
Must install center bolt in
z 2006,2007,2008,2009,2010,2011,2012,2013 Cequent Performance Products, Inc.
Made in China 30035IN 9/4/13 Rev. R
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
Side Bracket
Axle Center
*
Optional weld
pattern
Drivers side of F150 shown
1/4 1.5-3
1/4 2
*
1/4 2
1/4 2
*
May need to move slightly to
avoid interference with fuel lines
Measure from Rear Edge
of truck bed to rear edge
of base rail.
Long bracket
Short bracket
King Pin Center approx.. 1-1/2”
forward of axle center.
Bed Sill
Front of
Vehicle
SHEET 10 0F 21
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.