Draw-Tite 65031 FRONT MOUNT RECEIVER - Manual

Existing Weldnuts
Frame Rail Access Hole
Front Mounted Receiver
Installation Instructions
Toyota Tundra
Toyota Sequoia
Part Numbers:
65031
1. Remove skid plates and tow hooks from vehicle and return to customer.
2. Raise receiver into position and install four (4) M12 bolts.
3. Using receiver as a template, drill two (2) holes in frame.
4. Insert handle nuts thru access holes in frame and install two (2) 1/2”-13 bolts as shown.
Tighten all 1/2” GR5 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
Rev. A 11-07-05 N65031 Sheet 1 of 3 z 2005 Cequent Towing Products
Conical Washer, 1/2” Qty. (4) 6 Flat Washer, 1/2” Qty. (2) 3
Hex Bolt, M12 x 1.25 x 35 Qty. (4) 5 Lock Washer, 1/2” Qty. (2) 2
Handle Nut, 1/2” Qty. (2) 4 Hex Bolt, 1/2”-13 x 1-3/4” Qty. (2) 1
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft (92 N-m).
Equipment Required:
Wrenches: 3/4”, 18mm, 19mm
Drill Bits: 1/2”
Fastener Kit: F65031
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000
Frame Rail
Fascia
Receiver Shown In Proper Position
Hitch Requires 5/8” Pin and Clip
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.