Draw-Tite 30035 FIFTH WHEEL RAILS - Manual (Page 10)

Ford ‘04 & UP F-150, 5.5’, 6’, & 8’ BEDS - requires Bracket Kit 58426
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Do not drill through both walls of frame. Drill only through wall of frame to which bracket is mounted.
2. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the ~4” between parallel rows of
spot welds where the bed sill sits.
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
3. Remove jounce block from
bottom of frame on both sides.
4. When brackets are in place
one of the front 2 holes should
line up with a hole in the frame.
A hole will need to be drilled in
the frame at the rearward
bracket hole.
5. Pull carriage bolts with bolt
plates (using supplied pull wire)
through the hole in the bottom
of frame (where the jounce
block was removed) and
through the rear hole in each
bracket. On the forward
brackets a carriage bolt, bolt
plate and a 1” washer should
be pulled through the forward
hole, rearward brackets a
R
O
W
1
R
O
W
2
R
O
W
3
R
O
W
4
29 5/16” Long Box,
6’ Box, & 5.5’ Box
Front of
Vehicle
Rear Edge of
Truck Bed
Measure from Rear Edge of
truck bed to rear edge of
base rail.
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
z 2006,2007,2008,2009,2010,2011,2012,2013 Cequent Performance Products, Inc.
Made in China 30035IN 9/4/13 Rev. R
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc. CEQUENT
PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
responsibility of the installer to prevent damage due to installation.
hole, rearward brackets a
carriage bolt, bolt plate and
13/16” washer.
6. Replace the jounce block.
Side Bracket
Axle Center
Drivers side of F150 shown
King Pin Center approx. 1 1/2”
forward of axle center.
Bed Sill
Driver Side Brackets
Jounce Block
Hole in Frame
Hole in Frame
Drilled Hole
Drilled Hole
Carriage Bolt
Bolt Plate
Washer, Filling larger
hole in frame
Frame
Bracket
Lockwasher
Nut
FRONT OF VEHICLE
Do not install on a truck with
a 5.5’ long bed unless the
trailer is equipped with a
Sidewinder Pinbox Coupler.
SHEET 9 0F 21