Draw-Tite 65048 FRONT MOUNT RECEIVER - Manual

Front Mounted Receiver
Installation Instructions
Jeep Wrangler
Part Numbers:
65048
1. Remove, if present, plastic shield, OEM tow hooks, and upper bumper bolts.
2. See proper figure for fastener installation.
3. If desired, trim and reattach plastic shield. CONSULT VEHICLE OWNER BEFORE TRIMMING.
NOTE: DO NOT REATTACH TOW HOOKS.
Tighten all M10 CL10.9 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
Rev. A 2-17-06 65048N Sheet 1 of 3 z 2006 Cequent Towing Products
Spacer, 1-1/2” x 2” x 1/4”, Zinc Plated
Qty.
(2)
4
Flat Washer, 7/16”
Qty.
(6)
7 Spacer, 1-1/2” x 2” x 1/4”, Painted Black
Qty.
(2)
3
Conical Washer, 3/8”
Qty.
(2)
6 Conical Washer, 1/2”
Qty.
(4)
2
Hex Bolt, M10 x 1.50 x 45
Qty.
(2)
5 Hex Bolt, 1/2”-13 x 1-3/4”
Qty.
(4)
1
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
Equipment Required:
Wrenches: 10mm, 15mm, T-45 or T-55
Drill Bits: None
Fastener Kit: 65048F
CARGO CAPACITY – DO NOT EXCEED
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000
Receiver Shown In Proper Position
Bumper
Remove
Existing Fasteners
Recovery
Eye
FIGURE 1
1997 And Later
Remove
Existing Fasteners
FIGURE 2
1987 Through 1996