Draw-Tite 41933 ULTRA FRAME RECEIVER - Manual

1
5
6
2 3 2 4
2
2
4
7
2
4
Installation Instructions
Ford F-150
Lincoln Mark LT
Part Numbers:
41933
Equipment Required:
Wrenches: 3/4”, 7/8”
1. Raise hitch into position as shown in Figure 1. The bumper is not shown for clarity.
2. Use fasteners to attach the hitch to the bumper bracket. Make sure that round holed spacers are placed between the back of
the bumper bracket and the hitch.
3. Use pull wires to feed carriage bolts and blocks through the access holes in the sides of the frame. Position the carriage bolts
and blocks through the holes in the frame and the bracket of the hitch as shown in Figure 2.
4. Install the remaining washers and nuts on the bolts and tighten all nuts.
Tighten all ½-13 grade 5 fasteners with torque wrench to 75 Lb.-Ft.
Tighten all ½-13 grade 8 fasteners with torque wrench to 110 Lb.-Ft.
Rev. A 10-12-05 41933N Sheet 1 of 3 © 2005 Cequent Towing Products
Pull Wire Qty. (1) 8 Hex Nut, 1/2” (2 are red -grade 8) Qty. (6) 4
Spacer, 1” x 3 “ x 1/4”, Square Hole Qty. (2) 7 Spacer, 1” x 2” x 1/4”, Round Hole Qty. (2) 3
Carriage Bolt, 1/2-13 x 1-3/4” Grade 5 Qty. (2) 6 Conical Washer, 1/2” Qty. (10) 2
Hex Bolt, 1/2-13 x 1-1/2” Grade 5 Qty. (2) 5 Hex Bolt, 1/2-13 x 2.00” Grade 8 Qty. (2) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 41933F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
1,000 10,000
Weight Carrying
Ball Mount
1,200 12,000 Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU3
FIGURE 2
Pull
Wire
Frame Rail
Hitch
Bracket
Access Hole
Bumper/
Fascia
Frame Rail
Hitch Shown In Proper Position
FIGURE 1
Frame Rail
Bumper
Bracket
8
RED
RED – GRADE 8 NUT
THIS LOCATION ONLY
RED – GRADE 8 NUT
THIS LOCATION ONLY