Draw-Tite 65032 FRONT MOUNT RECEIVER - Manual

Front Mounted Receiver
Installation Instructions
Ford Explorer - 4 Door Only
Mercury Mountaineer
Part Numbers:
65032
1. Raise receiver into position and install fasteners in four (4) existing slots as shown.
NOTE: On Ford Explorer air dam can be trimmed for better tow hook clearance.
2. Using receiver as template drill one (1) hole in each frame rail as shown.
3. Install remaining fasteners.
Rev. A 11-07-05 N65032 Sheet 1 of 3 z 2005 Cequent Towing Products
Nut Block Handle Assembly Qty. (6) 4 Lock Washer, 1/2” Qty. (2) 2
Conical Washer, 1/2” Qty. (4) 3 Hex Bolts, M12 x 1.25 x 40 Qty. (6) 1
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft (125 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Receiver Shown In Proper Position
Frame Rail
Fascia
Drilled Hole
Existing Slots
Frame Rail
Equipment Required:
Wrenches: 19mm
Drill Bits: 1/2”
Fastener Kit: F65032
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000