B&B Electronics ZXT9-MB2A-KIT - Manual - Manual (Page 6)

Document Number: ZXTxRM-5110m
Page 6
Section One – Overview
1.0 Overview
1.1 Prerequisites
This manual assumes you have a basic understanding of wireless communications, Serial Protocols
(RS-232/422/485), and basic electronics.
1.2 Safety Information
WARNING
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard
for human exposure to radio frequency electromagnetic energy emitted by FCC regulated equipment
as a result of its actions in Docket 93-62 and OET Bulleting 65 Edition 97-01.
1.3 Installation Information
Operating Voltage 10 to 30 VDC
Maximum Surrounding Ambient Air Temp 74°C
Wiring Terminals Use Copper Wire Only, One Conductor Per Terminal
Wire Range 30 to 12 AWG
Tightening Torque 0.5 to 0.6 Nm
Temperature Rating of Field Installed Conductors 105°C minimum, sized for 60°C ampacity.
DO NOT Operate unless all RF connectors are secure and any open connectors are
properly terminated
DO NOT Operate the equipment near electrical blasting caps or in an explosive
atmosphere.
All equipment must be properly grounded for safe operations. All equipment should be
serviced only by a qualified technician.
A separation distance of 20 cm or more should be maintained between the antenna of
this device and persons during device operation. To ensure compliance, operation at
closer than this distance is not recommended. The antenna used for this device must not
be co-located in conjunction with any other antenna or transmitter.