B&B Electronics ZXT9-MB2A-KIT - Manual - Manual (Page 50)

Document Number: ZXTxRM-5110m
Page
50
5.3.2.2 Radio Modem Settings (ZXT24-RM)
Figure 5-29 Basic Radio Modem Settings (ZXT24-RM)
Basic Modem Settings Tab :
The Basic Modem Settings Tab is used to configure the following
parameters
Model Number: Displays the radio modem model number.
Function Set: Functions supported by firmware.
Version: Firmware version.
Channel Number: Set/read the channel number (Uses 802.15.4 channel
numbers). The range is 0xC to 0x17
Network Identifier: Set the PAN (Personal Area Network) ID. Use
0xFFFF to send message to all PAN's. The range is 0x0 to 0xFFFF.
Destination Address: Set/read the lower 32 bits of the 64 bit destination
address. Set the DH register to zero and DL less than 0xFFFF to
transmit using a 16 bit address. 0x000000000000FFFF is the broadcast
address for the PAN. The range is 0x0-0xFFFFFFFF.
Baud Rate: Set/read the serial interface baud rate for communication
between modem serial port and host. Request non-standard baud rates
with values above 0x80 using a terminal window. Read BD register to
find actual baud rate achieved
Parity: Not Selectable
Stop Bit: Not Selectable
Flow Control: Not Selectable