B&B Electronics ZXT9-MB2A-KIT - Manual - Manual (Page 40)

Document Number: ZXTxRM-5110m
Page
40
5.3.2.1 Radio Modem Settings (ZXT9-RM)
Figure 5-24 Basic Radio Modem Settings (ZXT9-RM)
Basic Modem Settings Tab :
The Basic Modem Settings Tab is used to configure the following
parameters
Model Number: Displays the model number of the radio modem.
Function Set: Dependent on firmware.
Version: Dependent on firmware.
Channel Number: Set/read spread spectrum channel on which modem
communicates. Separate channels minimize interference between
multiple sets of modems operating in the same vicinity. The Range is:
0x0 to 0x9. Default is 00.
Network Identifier: Set/read radio modem Vendor Identification Number
(VID). Only radio modems with matching VIDs can communicate with
each other.
The range is 0x0-0x7FFF. Default is 3332.
Destination Address: Set/read module's destination address. The range
is 0x0-0xFFFF. Default is FFF7.
Baud Rate: Select serial interface rate (speed for data transfer between
radio modem and host). Serial data rate does not have to match the RF
data rate which is adjustable using the BR command on the Advanced
Tab. If the serial data rate is set higher than the RF data rate, CTS may